DeWalt D51430 Mode D'emploi page 20

E N G L I S H
• Do not use any stands for mounting the tool to
a support.
• Do not disassemble or block any parts of the
fastener driving tool such as the safety yoke.
• Prior to each operation check that the safety and
triggering mechanism is functioning properly and
that all nuts and bolts are tight.
• Do not use the equipment as a hammer.
• Never point any operational fastener driving tool
at yourself or at any other person. Do not use the
tool in applications requiring operation close to
the body.
• While working, hold the tool in such a way that
no injuries can be caused to the head or to the
body in the event of a possible recoil due to
a disruption in the energy supply or hard areas
within the workpiece.
• Never actuate the fastener driving tool into free
space.
• Consider the conditions in the work area.
Fasteners can penetrate thin workpieces or slip
off corners and edges of the workpiece, and thus
put people at risk.
• Do not drive fasteners close to the edge of the
workpiece.
• Do not drive fasteners on top of other fasteners.
• In the work area, carry the tool at the workplace
using only one handle, and never with the trigger
actuated.
• Unload the tool after use and before performing
any maintenance.
The following pictograms are shown on the tool:
Pneumatic tool with safety yoke.
Do not use the tool on a ladder.
Compatible fastener angles.
Maximum number of fasteners in
magazine.
Fastener width.
20
All manuals and user guides at all-guides.com
Package contents
The package contains:
1 Stapler
1 Sequential action trigger
1 Safety glasses
1 Allen key 3 mm
1 Allen key 4 mm
1 Instruction manual
1 Exploded drawing
• Check for damage to the tool, parts or accessories
• Take the time to thoroughly read and understand
Description (fig. A)
Your stapler D51430/D51431 has been designed for
driving fasteners into wooden workpieces.
1 Trigger
2 Lock-off switch
3 Depth adjustment slider
4 Contact trip
5 Magazine
6 Magazine latch
7 Air fitting
Assembly and adjustment
Trigger selection (fig. B)
These tools are assembled with a bump action
trigger. A sequential action trigger is also included
with the original packaging. For definitions of
„bump action" and „sequential action", see below.
- The grey trigger with a single fastener printed on
- The black trigger with three fasteners printed on the
Fastener length.
Max. operating pressure.
Tool weight.
which may have occurred during transport.
this manual prior to operation.
the side is the sequential action trigger.
Installation of this kit causes the tool to function
in sequential action mode.
side is the bump action trigger. Installation of this kit
causes the tool to function in bump action mode.