Publicité
English
5. Initial rinse
"Before operating the machine, perform a rinse of
the internal circuits and change the water in the
boiler."
4.1
Changing the water in the internal groups circuits
Remove the filter carriers (21, 25) of the distributor groups.
Via the continuous distribution key (30), empty the water from
each group for approximately one minute. Repeat this
operation twice.
4.2
Changing the water in the boiler
Ensure that the indication on the display (78) corresponds to
the working pressure value.
Keep the hot water distributor key (13) pressed down for
approximately 5 seconds, the water from the boiler will drain
from the hot water nozzle (10).
When only steam is issued from the nozzle (10), press the
hot water distributor key (13) again.
The machine will return to its normal functions and the boiler
will be refilled with water.
6. Drinks distribution - coffee
Remove the filter carrier (21 or 25), clean it of the used coffee
grounds and refill it with 1 or 2 doses of ground coffee,
according to the filter carrier used.
Press the coffee evenly in the filter, using the dose-grinder
press.
Remove any coffee grounds from the edges of the filter.
Insert the filter carrier (21 or 25) to the group, locking it firmly
in place. Position the cup (or cups) under the spout (or
spouts) of the filter carrier (21 or 25).
Press the coffee dispensing button (30) and dispense.
When the desired dose is obtained, press button (30) again
to stop dispensing.
All manuals and user guides at all-guides.com
37
13
10
78
English
30
21
30
21
Publicité
