Publicité
Les langues disponibles
Les langues disponibles
D. trek
s setuP (contInueD)
®
You are 10 steps away from starting your treatment with
trek
®
s. please follow step by step.
1.
clean/Disinfect nebulizer cup:
to properly clean and/or disinfect your nebulizer prior
to first use. Re-assemble nebulizer.
2.
set-up compressor:
place the compressor on a
flat, stable surface free of dust. avoid cushioned,
upholstered or carpeted surfaces. Make sure power
switch is turned to , the "oFF" position. activate
and attach the timestrip
®
trek
s compressor as explained in section e.
®
3.
connect tubing to compressor:
wing tip™ tubing to the air outlet on the compressor.
it should fit snugly (Fig. F).
4.
Load medication:
open the inspiratory valve cap of
nebulizer by lifting the cap (Fig. g). pour medication
into nebulizer cup. Never fill past the max. fill line of
8 ml.
5.
Attach mouthpiece or mask:
attach the mouthpiece to the nebulizer outlet with the
expiratory valve facing up. then close the inspiratory
valve cap by pressing firmly on the nebulizer top. if
using a mask, refer to the mask instructions for use.
6.
Attach tubing to nebulizer cup:
end of the wing tip™ tubing to bottom of paRi
reusable nebulizer (Fig. h).
7.
starting treatment:
sit in a relaxed, upright position and
turn the compressor "oN" .
F
H
All manuals and user guides at all-guides.com
Refer to sections F & g
label to the front of the
insert one end of
if using the mouthpiece,
Firmly press the other
Questions? 1.800.FAst.neB (327.8632) | PArI.com/treks
8.
nebulizer Position:
place the mouthpiece on top of
tongue and close lips around it. take slow, deep
breaths. as you inhale, the inhalation valve opens.
9.
Breathing:
For mouthpiece, inhale and exhale slowly
through your mouth. as you exhale, the valve on
the mouthpiece opens to allow the exhaled mist to
escape. For mask, place mask over nose and mouth
and inhale and exhale slowly.
10.
complete treatment:
continue until the medication is
gone or you hear a slight "sputtering" sound. turn
compressor "oFF" .
note: the Pari treK
S compressor is protected by a
®
thermal switch. if the Pari treK
®
its temperature limit it will automatically turn off to prevent
damage to the Pari treK
S compressor. in the unlikely
®
event this occurs, the Pari treK
®
approximately 30 minutes to cool down prior to resuming the
treatment . Switch off the Pari treK
cool down before restarting . if the Pari treK
does not start after it is switched on after cooling for 30
minutes, please allow another few minutes for the compressor
to cool and try again. if you need to use the Pari trek
longer than 30 minutes, please contact Pari at 1.800.faSt.
neB (327.8632).
G
S compressor has reached
S compressor may need
®
S compressor and let it
S compressor
®
S for
®
EN-6
Publicité
