Extremis AMAi Manuel page 20

Warnings – Assembly text instructions – Maintenance
English
WARNINGS
General
• Do not use any sharp tools to open the
packaging.
• We strongly advise against using power tools.
• Tripping hazard, mind your step.
• Do not put out cigarettes on the table.
• Not grafitti proof.
• Do not leave children unattended whilst playing
on the table.
• away from babies and children.
• Colors can differ over years and from batch to
batch.
Product
• Do not drag the table, but carry it with minimum
2 people.
• Anchoring the product has to be done by
qualified people.
• For anchoring: use suitable bolts or screws from
a specialized store depending on the material
your terrace is made of.
• Tests in a windtunnel have shown that the shade
withstands wind speeds up to 49 km/h (31 mph).
Still, we strongly advise to close it sooner (from
wind speed 28 km/h (18 mph) scale is the rule of
thumb).
High-tech polyester
• Shake or brush off loose dirt immediately.
• Do not use any aggressive detergents as they will
remove the protective coating of the fabric.
• We strongly advise you not to use a high-pressure
hose for cleaning.
Stainless steel
• Very good UV colour fastness.
• Flame retarding: NEN-EN13501-1 A1 - Class A1
products will not contribute to fire in any stage,
including fully developed fire. For this reason,
they are assumed to be capable of satisfying all
requirements of all lower classes as well.
• Watch out, stainless steel isn't entirely rustproof!
Be sure to avoid contact with iron objects. If it
does show signs of rust, clean with rust remover
as quickly as possible.
20
Powder coating
• White powder coating requires more
maintenance.
• Do not use abrasive scouring powders or
scourers as they will scratch the surface.
• Color can fade to some extent when exposed to UV.
• Flame retarding - NEN-EN13501-1 A2-sl -
Satisfying the same criteria as Class B for the
SBI-test according to EN13823. In addition,
under conditions of a fully developed fire these
products will nog significantly contribute to the
fire load and fire growth.
• Dark colors can get very hot in sunny weather.
ASSEMBLY INSTRUCTIONS
Shade & Market shade - p10
1. Remove one of the end caps by unscrewing the
four bolts and set everything carefully aside.
2. Slide two of the cylindrical pins supplied into
the two outer slots in the top profile. Make sure
they are placed in the top slot as shown in the
drawing.
3. Now also slide the three flat plates into each slot
of the top profile as shown in the drawing.
4. Now slide the shade stopper profiles into the
same slots as the cylindrical pins.
5. Now slide another cylindrical pin into the same
slots.
6. Replace the end cap using the four bolts from
step 1.
7. Each time, position the center hole of the plate
above the holes in the upper profile.
8. Now mount the three rectangular tubes in the
center holes of the six flat plates each using an
M6x10 screw and an M6 spring washer.
a. Fix the screws and spring washers into the
rectangular tube through the side.
b. Then tighten them using a 5 mm Allen key
through the lower holes in the rectangular tube.
9. Next go back to step 6 in the LAB152-1 manual to
continue assembling your AMAi.
10. Next slide the three stainless steel tubes through
the rectangular tubes. Note: make sure the
bracket is facing upwards.
11. Next attach the three stainless steel tubes to the
rectangular brackets using two M8x20 bolts
each.
12. Now hang the fabric on the AMAi by sliding it over
the three stainless steel tubes. Make sure the side
with the two black cords faces outwards.