Publicité
Les langues disponibles
Les langues disponibles
Ventilate room and seek medical attention in case of medical
symptoms. Gas can damage respiratory tract.
• Improper operation conditions may lead to battery electrolyte leak,
avoid contact with the substance. In case of accidental contact, flush
the electrolyte abundantly with water. In case of contact with eyes,
additionally seek medical attention. Leaked electrolyte may cause eye
irritation or burns.
• Do not disassemble the battery – there is a risk of short circuiting.
• Do not use power tool battery in rain.
• Always keep the battery away from sources of heat. Do not leave
the battery for a long time in high temperature (in direct sunlight,
in proximity of heaters and wherever the temperature exceeds 50°C).
Safety instructions for battery charger
• This equipment is not intended for use by persons with restricted
physical, sensory or mental capabilities (including children) or persons
who have no experience or are unfamiliar with the equipment, unless
the use is supervised or carried out in accordance with equipment
use instructions handed over by persons responsible for their safety.
• Pay attention to children so they don't play with the equipment.
• Do not expose the charger to humidity or water. Ingress of water
into the charger increases risk of electric shock. Use the charger only
in dry rooms.
• Disconnect the charger from power supply before starting any
maintenance or cleaning.
• Do not use the charger when placed on flammable surface (e.g.
paper, textiles) or in proximity of flammable substance. Greater
charger temperature when charging increases risk of fire.
• Check condition of the charger, cable and plug before each
use. Do not use the charger if any damage is found. Do not try
to disassemble the charger. All repairs should be made at an
authorised service workshop. Improper charger assembly may cause
electric shock or fire.
• Children and persons who are physically, emotionally or mentally
disabled and other persons, whose experience or knowledge is
insufficient to use the charger while following all safety rules should
not use the charger without supervision of person responsible for
their safety. Otherwise there is a risk of improper use and injuries in
consequence.
• When the charger is not in use, it should be disconnected from the
mains network.
CAUTION! The design is assumed to be safe, protection measures and
additional safety systems are used, nevertheless there is always a
small risk of injuries at work.
Li-Ion batteries may leak, set on fire or explode when heated to high
temperature or short-circuited. Do not store the batteries in a car in
hot and sunny days. Do not open the battery. Li-Ion batteries contain
electronic protection devices that, if damaged, may cause fire or
explosion of the battery.
Explanation of used symbols
1
2
3
5
6
7
9
10
11
13
14
15
17
18
4
8
12
16
10
1.
CAUTION! Use precaution measures.
2,3. Read instruction manual, observe warnings and safety conditions
therein!
4.
Use personal protection equipment (protective goggles, earmuff
protectors).
5.
Remove the battery from the device before starting any
adjustments or cleaning related tasks.
6.
Use protective gloves.
7.
Keep the tool away from children.
8.
Use protective clothes.
9.
Use working shoes.
10. Protect the tool from moisture.
11. Do not put your hands or legs close to cutting parts.
12. The device is designed for outdoors use.
13. Disconnect the charger before repairs.
14. Protection class 2.
15. The charger is designed to operate indoors in dry environment.
16. Do not throw cells into fire.
17. Maximum permissible cell temperature.
18. Recycling
CONSTRUCTION AND USE
Cordless hedge trimmer is a hand held device. Drive consists of a DC
commutator motor. Described hedge trimmer is designed for home
garden works, such as trimming hedges, bushes and shrubs. Any other
use, that is not allowed in this instruction manual, may cause damage of
the trimmer and constitute serious risk for the user. The hedge trimmer
is designed only for light duty use.
Use the tool only in accordance with its purpose.
DESCRIPTION OF DRAWING PAGES
Below enumeration refers to the device elements depicted on the
drawing pages of this manual.
Blade bar
1.
Guard
2.
Auxiliary handle
3.
Switch lock button
4.
Main handle lock button
5.
Switch
6.
Main handle
7.
Battery locking button
8.
Battery
9.
Charger
10.
LED diodes
11.
Button for battery level indication
12.
Battery level indicator (LED)
13.
* Differences may appear between the product and drawing
MEANING OF SYMBOLS
CAUTION
WARNING
ASSEMBLY / SETTINGS
INFORMATION
EQUIPMENT AND ACCESSORIES
1.
Blade bar shield - 1 pce
PREPARATION FOR OPERATION
REMOVING AND INSERTING THE BATTERY
• Push the battery lock button (8) and slide out the battery (9) (fig. A).
• Insert charged battery (9) into the handle holder, you should hear when
the battery lock button (8) snaps.
BATTERY CHARGING
The battery for the device is supplied partially charged. Charge the
battery in ambient temperature between 4°C and 40°C. New battery, or
one that has not been used for a long time, will reach full efficiency after
approximately 3 to 5 charge/discharge cycles.
• Remove the battery (9) from the device (fig. A).
• Connect the charger (10) to a mains socket (230 V AC).
Publicité
