Publicité
Les langues disponibles
Les langues disponibles
Dry Drilling
1. Connect the machine to an appropriate dust
extraction system.
2. Proceed as described above.
Wet Drilling
1. Connect the machine to an appropriate water
supply system.
2. Adjust the water flow as necessary.
3. Proceed as described above.
WARNING: DO NOT use wet drilling
(water cooling) when performing
overhead (upward) drilling.
WARNING: If any water comes out
of the drainage hole at the gear neck,
stop the work immediately and have
the machine repaired by an authorised
repair agent.
Drill Stand
D21582K
1. Drilling with the stand is only allowed
downwards or horizontally.
2. The stand must be fixed, either by bolts or
vacuum device.
NOTE: When using bolts for the stationary
stand, use either Cat. No.: D212825 for
concrete or D215826 for masonry.
MAINTENANCE
Your D
WALT power tool has been designed to
E
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
WARNING: To reduce the risk of
injury, turn unit off and disconnect
machine from power source before
installing and removing accessories,
before adjusting or changing set-
ups or when making repairs. Be sure
the trigger switch is in the OFF position.
An accidental start-up can cause injury.
Regularly take the tool to an authorized repair
agent for inspection. This includes checking the
carbon brushes, topping up oil in the gearcase and
replacement of the gearcase sealing ring.
Troubleshooting
If your tool seems not to operate properly, follow
the instructions below. If this does not solve the
problem, please contact your repair agent.
Core bit does not cut
Material too hard for core bit
• Choose a more appropriate core bit
(with softer segments).
• Apply wet drilling when appropriate.
Segments look glazed and polished
• Drill in abrasive material to re-expose diamond
segments.
Evacuated water too clear and too fluid
Water flow slows down the cutting action and
prevents the diamond segments to self-sharpen.
• Reduce water flow.
Dust accumulating in core bit
Accumulating dust slows down the drilling speed.
• Use the appropriate dust extraction device.
• Disengage drill bit regularly to evacuate cuttings.
Rotating speed not appropriate
• Refer to the technical data for proper speed
ratings.
Segments and core are burnt
• Increase water flow.
Segments wear too fast
• Choose a more appropriate core bit
(with harder segments).
• Reduce the pressure applied on the core bit.
Lubrication
Your power tool requires no additional lubrication.
Dust Extraction (dry operation)
WARNING: When performing a
dry cutting operation, connect a
dust extraction device designed in
accordance with the relevant regulations
regarding dust emissions.
Cleaning
WARNING: Blow dirt and dust out of
the main housing with dry air as often as
dirt is seen collecting in and around the
air vents. Wear approved eye protection
and approved dust mask when
performing this procedure.
ENGLISH
35
Publicité
