Thrustmaster RUN'N'DRIVE Manuel De L'utilisateur page 3

PLAYSTATION® 1
PLAYSTATION® 2
PLAYSTATION® 3
INSTALLING BATTERIES
Insert 2 LR03 / AAA type batteries in the battery compartment situated on the back of the gamepad (14).
OVERVIEW
• POWER ON/OFF switch (15)
- OFF position = the gamepad is off (and doesn't use up batteries).
- ON position = the gamepad is on.
• MOTORS ON/OFF switch (16)
- OFF position = vibration mode is disabled (uses less battery power).
- ON position = vibration mode is enabled (uses more battery power).
• "PC / PS3" USB selector (11)
Must always be set to the correct position before connecting your receiver's USB connector.
• MAPPING (7) and CONNECT (12) blue LEDs
- Both LEDs are on = connection established between gamepad and receiver.
- Both LEDs flash quickly = no connection between gamepad and receiver.
- The MAPPING LED is off = the gamepad is in standby mode or powered off.
- The MAPPING LED flashes slowly & continuously = please change batteries.
THE CONNECTION BETWEEN THE GAMEPAD AND RECEIVER
To force the connection in case of error: press the CONNECT button on the receiver
and simultaneously press the L2 + R2 + MAPPING buttons on your gamepad.
• STANDBY MODE
The gamepad switches off automatically:
- After 5 minutes of inactivity
- After 5 seconds in the event of error or loss of connection.
To wake up your gamepad: press START or use the POWER ON/OFF switch (15).
All manuals and user guides at all-guides.com
TABLE OF SUPPORTED MODES
Platform
PC
IS ESTABLISHED AUTOMATICALLY
2/14
Color of HOME button
MODE
"PS1"
"PS2"
"PS3"
"4 AXES" GREEN
"6 AXES"
(6)
OFF
RED
RED
RED