Publicité
HPW 155i PRO
MAINTENANCE AND CLEANING
WARNING
RISK OF ELECTRIC SHOCK
Prior to all work on the appliance, switch off the-
appliance and pull the power plug.Before repair
or maintenance, it is required to wait until the high
temperature of appliance's surface andhigh-pres-
sure water turn back to normal temperature and
pressure, or it may cause serious injury.
CHANGE OIL IN PUMP
Lubricant oil should be changed in the first 50
hours of operation and afterwards, every 100
hours.
• Loose oil drainage plug (Fig. 8.3).
• Tilt the opposite side of the oil drainage high-
er, making the oil drainage facing the oil drain
pan straightly.
• Remove the oil drainage plug and drain the
waste oil.
• After draining the oil completely, put the oil
drainage plug back.
• Tighten the oil drainage plug and fill in new
oil(SAE 5W-40), till the oil level indicator win-
dow is half covered by the new oil (Fig. 8.2).
• Put back the oil cap and tighten it (Fig. 81).
HIGH PRESSURE HOSE
• The high pressure hose is specially construct-
ed with reinforced walls, which can be easily
damaged and therefore, it should be stored
carefully.
• Do not drive vehicles over the hose.
• Do not expose the hose to sharp edges or cor-
ners. Misuse will lead to ballooning or prema-
ture failure and will invalidate warranty.
WATER FILTER CLEANING
Clean the sieve in the water connection regularly.
Remove the coupling from the water connection
and rinse with warm water to prevent any foreign
matter from clogging the pump.Clean the nozzle
with the needle provided, to clean-out the tool.
Remove the spray wand from the gun. Remove
any dirt from the nozzle hole and rinse.
ATTENTION
The sieve must not be damaged.Pull the sieve out
using flat pliers.Clean the sieve under running wa-
ter.Reinsert the sieve into the water connection.
ENVIRONMENTAL PROTECTION
Recycle raw materials instead of disposing as
waste. Machine, accessories and packaging should
be sorted for environment - friendly recycling. The
plastic components are labeled for categorized
recycling.
WARRANTY
This product is warranted in accordance with the
legal/ country specific regulations, effective from
the date of purchase by the first user. Damage
attributable to normal wear and tear, overload or
improper handling will be excluded from the war-
ranty. In case of a claim, please send the machine,
completely assembled, to your dealer or the offi-
cial service center.
English | 13
www.ffgroup-tools.com
Publicité
