Technical Data - Husqvarna 129DJX Manuel D'utilisation

T T o do the maintenance to the air filter
To clean the air filter
1. Remove the air filter cover and remove the air filter
(Picture 44).
2. Clean the air filter with warm soap water. Make sure
that the air filter is dry before you install it.
3. Replace the air filter if it is too dirty to fully clean it.
Always replace a damaged air filter.
4. If your product has a foam air filter, apply air filter oil.
Only apply air filter oil to a foam filter. Do not apply
oil to a felt filter.
To apply air filter oil to the air filter
CAUTION: Always use special air filter oil on
foam air filters. Do not use other types of oil.
WARNING: Do not get oil on your body.
Engine Specifications
Cylinder displacement
Electrode gap
Fuel tank volume
Idling speed
Maximum power speed
Power output
Spark plug
Maximum output shaft rotation
Emission durability period
Noise and Vibration Data
Equivalent vibration level (ahv, eq), equipped with grass blade, left handle -
see note 1
14
1. Remove the air filter cover and remove the air filter
(Picture 44).
2. Put the air filter in a plastic bag.
3. Put the air filter oil in the plastic bag (Picture 45).
4. Push the plastic bag to make sure the oil supplies
equally across the air filter.
5. Push on the air filter, while in the bag, to remove the
air filter oil that is not necessary. Remove the air
filter from the bag.
6. Install the air filter.
To add grease to the bevel gear
Make sure that the bevel gear is filled 3/4 full with bevel
gear grease (Picture 46).
To sharpen grass cutters and grass
blades
1. Sharpen grass cutters and grass blades with a
single-cut flat file.
2. Sharpen all edges of the grass cutters and blades
equally to keep the balance (Picture 48).

TECHNICAL DATA

unit 1 1 29DJX
(A05328CSHV)
3
cm 27,6
mm 0,5
3
cm 343
-1
min 2800-3200
-1
min 8000
kW 0,85
Husqvarna HQT-4
-1
min 7200
h 125
2
m/s 4,21
195 - 002 -