Troubleshooting - Dometic eStore Instructions De Montage Et De Service

eStore
12

Troubleshooting

Problem Cause
No voltage at The main switch is turned off
the battery (open).
terminals.
The fuse is defective.
eStore is in storage mode.
eStore is not configured
correctly.
eStore is over discharged.
eStore is defective.
Status LED eStore is in storage mode.
does not flash.
eStore is severely over
discharged.
eStore is defective.
EN
Troubleshooting
Remedy
➤ Turn on (close) the main
switch.
➤ Replace the fuse (see chap-
ter "Changing the fuse" on
page 24).
➤ Activate eStore.
➤ Configure eStore.
➤ Charge eStore with a charg-
ing current of < 10 A.
Note: Do not use intelligent
charging systems (with main
swtich open, the eStore ter-
minals have no voltage.
Some intelligent battery
chargers do not start if no
voltage is present).
➤ Contact an authorised work-
shop.
➤ Contact an authorised work-
shop.
➤ Activate eStore.
➤ Charge eStore with a charg-
ing current of < 10 A.
Note: Do not use intelligent
charging systems (with main
swtich open, the eStore ter-
minals have no voltage.
Some intelligent battery
chargers do not start if no
voltage is present).
➤ Contact an authorised work-
shop.
➤ Contact an authorised work-
shop.
25