Connecting Estore - Dometic eStore Instructions De Montage Et De Service

eStore
8

Connecting eStore

8.1 Opening the cover of the pole
➤ Release the closure by gently pushing down the pin in the middle of the
closure (fig. 3 1, page 3).
Take care not to push it through completely.
➤ Open the cover (fig. 3 2, page 3).
➤ Remove the unlocked closure (fig. 3 3, page 3).
➤ Note the positions of the closure (fig. 4 , page 4):
– 1: unlocked
– 2: ready (armed)
– 3: locked
8.2 Closing the cover of the pole
➤ Slide back the pin of the closure.
➤ Put in the ready (armed) closure (fig. 5 1, page 4).
➤ Close the cover(fig. 5 2, page 4).
➤ Lock the closure by gently pushing down the pin in the middle of the
closure (fig. 5 3, page 4).
Take care not to push it through completely.
8.3 Activating eStore
I
NOTE
eStore is supplied in a storage mode that reduces self-discharge
during storage. To use eStore, you must activate it first.
➤ Open the cover of the pole (see chapter "Opening the cover of the pole"
on page 17).
➤ Connect positive pole (fig. 2 1, page 3) and negative pole (fig. 2 2,
page 3) with a low output current, 12 Vg battery or charger.
✓ The Status LED (fig. 1 2, page 3) flashes yellow.
✓ eStore ist activated.
EN
Connecting eStore
17