Electrical Safety; Before First Use - Black & Decker Dustbuster V4800 Mode D'emploi

E N G L I S H
Never pull the charger lead to
N
disconnect the charger from
the socket. Keep the charger
lead away from heat, oil and
sharp edges.
After use
Unplug the charger before
N
cleaning the charger or
charging base.
When not in use, the appliance
N
should be stored in a dry place.
Children should not have
access to stored appliances.
Inspection and repairs
Before use, check the appliance
N
for damaged or defective
parts. Check for breakage of
parts, damage to switches
and any other conditions that
may affect its operation.
Do not use the appliance if any
N
part is damaged or defective.
Have any damaged or
N
defective parts repaired or
replaced by an authorised
repair agent.
Regularly check the charger
N
lead for damage. Replace the
charger if the lead is
damaged or defective.
Never attempt to remove or
N
replace any parts other than
those specified in this manual.
Battery
Never attempt to open the
N
battery for any reason.
Do not expose the battery to
N
water.
Do not incinerate the battery.
N
When disposing of batteries,
N
follow the instructions given
in the section "Protecting the
Environment".
Charger
Do not expose the charger to
N
water.
Do not open the charger.
N
6

ELECTRICAL SAFETY

Your charger has been designed
for a specific mains voltage.
Always check that the mains
voltage corresponds to the
voltage on the rating plate.
Your charger is double
insulated in accordance with
EN 60335; therefore no
earth wire is required.
Never attempt to replace
the charger unit with a
regular mains plug.
INSTALLATION
Fitting the charging base to the
wall (fig. B)
The charging base can be fitted
to the wall to provide a
convenient storage and charging
point for the appliance.
Find a suitable indoor
N
location near a mains outlet.
Position the charging base as
N
shown and mark the location
of the mounting holes (6) on
the wall.
Drill a hole (ø 6 mm, approx.
N
35 mm deep) at each of the
marked locations.
Insert the wall plugs provided
N
into the holes.
Fit the charging base to the
N
wall using the screws provided.
Make sure to guide the charger
lead through the slot (7).
Excess lead can be stored at
the rear of the charging base.

BEFORE FIRST USE

Before first use, the battery must
be charged for at least 16 hours.
Before charging, preferably
N
discharge the battery by
operating the appliance until
the motor stops.
Charge the battery as
N
described below.