Electrical Safety - Black & Decker CUA525BH Mode D'emploi

The appliance/battery must be
u
placed in a well ventilated area when
charging.

Electrical safety

Symbols on the charger
Read all of this manual carefully before using the
#
appliance.
This tool is double insulated; therefore no earth wire
is required. Always check that the power supply
$
corresponds to the voltage on the rating plate.
The charging base is intended for indoor use only.
Labels on appliance
The following symbols appear on this appliance along with the
date code
Read all of this manual carefully before
using the appliance
Only use with charger S010Q 23 /
S010Q 23 / SSC-230040XX
SSC-230040XX
Features
This tool includes some or all of the following features.
1. On/off power switch
2. Handle
3. Handle / wand
3a. Flexible tube port
3b. Tube extension latch
4. Extendable crevice tool
5. Lift away canister vac
5a. Dust bowl
6. Dust bowl lid
7. Charging base
8. Dust bowl lid hinge
9. Hose connector
10. Flexible hose
11. Handle / wand release button
12. Chassis
12a. Light
13. Chassis hose port
14. Floor head
15. 3-in-1 Accesssory tool
16. Pet crevice tool (CUA525BHP only)
17. Long brush tool (CUA525BHA only)
(Original instructions)
Use
Switching on and off (Fig. A)
To switch on, press the on/off switch (1).
u
Unit starts in mid performance setting. Performance can
u
be adjusted using power control slider (J2
To switch off, press the on/off switch (1).
u
Note: The unit has an intuitve 'standby' mode that allows it
to remember the last settings applied for a few minutes upon
starting up.
Note: The unit will not start up if the compacting handle (19)
is in operation or the dust bowl assembly (5a) has been re-
moved. This will be indicated by the power sensor and battery
sensor LEDs rotating in a clockwise pattern.
Note: If leaving the appliance when in use, position the upright
unit, in such a way that any inadvertent fall would contact a
wall or corner and otherwise be away from people and pets.
Control panel (Fig. J)
The unit is equipped with a smarttech control panel providing
Intelligent sensor technology for a more intuitive cleaning
experience. The features incorporated are:
J1 FLOORSENSOR Touch Button
Intelligent floor sensor technology increases suction on carpets and
switches to Economy Mode for lighter tasks, such as hard floor cleaning,
thus optimising the battery run time this feature is active when the LED
(J1a) is lit. In order to maximise runtime on all surfaces, switch this
feature off by touching area (J1).
J2 Power contol Touch Slider
Touch button panel allows you to control the level of power to the unit
from minimum to maximum by sliding finger along this area.
J3 Beater bar Touch Button
Allows you to turn on and off the beater bar function by touching this area.
J4 Power indicator
Allows you to monitor the level of power being used.
J5 BATTERYSENSOR Indicator
The LED battery indicator displays the remaining charge and warns you
when the battery is low. The final LED will flash continuously when there
is only 1 minute of runtime remaining. All LEDs will flash when the unit is
discharged.
ENGLISH
9