Electrical Safety; Symbols On The Charger - Black & Decker NVB115W Mode D'emploi

ENGLISH
Do not expose the charger to water.
u
Do not open the charger.
u
Do not probe the charger.
u
The appliance/tool/battery must be
u
placed in a well ventilated area when
charging.

Electrical safety

Your charger has been designed for a
specific voltage. Always check that the
mains voltage corresponds to the voltage
on the rating plate. Never attempt to
replace the charger unit with a regular
mains plug.

Symbols on the charger

Read all of this manual carefully
before using the appliance.
This tool is double insulated;
therefore no earth wire is
required. Always check that the
power supply corresponds to
the voltage on the rating plate.
The charging base is intended
for indoor use only.
Labels on appliance
The following symbols appear on this appliance along with the
date code:
Only use with charger S003AQ 15
S003AQ 15
Features
This tool includes some or all of the following features.
1. On/off switch (press and hold)
2. Bowl release button
3. Dust bowl
4. Charger
5. Charging bracket
Fig. A
6. Dry pick up cloth filter (NVB units Only)
6
(Original instructions)
7. Pre-filter (NVB units Only)
8. Wet/Dry foam insert (WDB units Only)
9. Wet/Dry deflector (WDB units Only)
Fig. B
10. Squeegee (WDB___WA units Only)
11. Brush tool (WDB___WA and NVB___WA units Only)
12. Crevice tool (WDB___WA and NVB___WA units Only)
Installation
Wall Mounting (fig. C)
The product can be attached to a wall to provide a convenient
storage and charging point for the appliance.
When fixing to a wall, make sure that the fixing method is
suitable for the wall type and is appropriate to the weight of
the appliance.
Mark the location of the screw holes (within reach of an
u
electrical outlet for charging the vac while it is on the wall
bracket).
Fix the mounting bracket to the wall using appropriate
u
screws and plugs for the type of wall and weight of the
appliance.
Hang the appliance on the wall by placing the opening
u
on the base of the vac over the hooks in the wall mount
charging bracket.
Assembly
Accessories (fig .B)
These models may be supplied with some of the following
accessories:
A squeege tool (10) for wet use on hard surfaces.
u
A brush tool (11) for furniture and stairs.
u
A crevice tool (12) for confined spaces.
u
Fitting (Fig. D)
Insert the appropriate accessory into the front of the
u
appliance. Make sure that the accessory is pushed fully in.
Use
Before first use, the battery must be charged for at least
u
24 hours.
Place the appliance on the charging bracket whenever it is
u
not in use.
Warning! Before charging, be sure to empty all liquid contents
and dry thoroughly, to avoid damage to your appliance.
Charging the battery (Fig. C)
Make sure that the appliance is switched off. The battery
u
will not be charged with the on/off switch (1) pressed.
Place the appliance on the charging bracket (5).
u
Plug in the charger. Switch on at the mains.
u