Protecting The Environment - Black & Decker Dustbuster V4800 Mode D'emploi

E N G L I S H
Brush any loose dust off the
N
filters.
Wash the filters in warm,
N
soapy water. The bowl can
also be washed if necessary
(fig. J).
Make sure the dust bowl and
N
filters are dry.
Refit the filters (12 & 13) onto
N
the appliance, twisting them
counterclockwise until they
lock into place.
Refit the dust bowl onto the
N
appliance. Make sure the dust
bowl clicks into place.
Important! Optimum dust
collection will only be achieved
with clean filters and an empty
dust bowl. If dust begins to fall
back out of the appliance after
switching it off, this indicates that
the dust bowl is full and must be
emptied.
Never use the appliance
N
without the filters.
Do not immerse the
N
appliance in water (fig. K).
Replacing the filters (fig. G & I)
The filters should be replaced
every 6 to 9 months and
whenever worn or damaged.
Replacement filters are available
from your Black & Decker dealer
(cat. no. VF20).
Press the release button (2)
N
and remove the dust bowl (3)
(fig. G).
Remove the filters (12 & 13)
N
by twisting them clockwise
(fig. I).
Fit the new filters (12 & 13)
N
onto the appliance, twisting
them counterclockwise until
they lock into place.
Refit the dust bowl onto the
N
appliance. Make sure the dust
bowl clicks into position.
8
PROTECTING THE
ENVIRONMENT
Should you find one day
that your Black & Decker
product needs replacement,
or if it is of no further use to
you, think of the protection
of the environment.
Black & Decker repair agents
will accept old Black & Decker
products and ensure that
they are disposed of in an
environmentally safe way.
Battery (fig. L)
If you want to dispose of the
product yourself, the battery
Cd must be removed as
described below and
disposed of in accordance
with local regulations.
Do not short-circuit the
battery terminals.
Preferably discharge the
N
battery by operating the
appliance until the motor
stops.
The battery is located under the
back end of the appliance.
Remove the crevice tool from
N
the accessory holder.
Push the slider (14) towards
N
the front of the product.
Remove the accessory holder.
N
Strike the product on a firm
N
and stable surface as shown in
fig. L to dislodge the battery.
Alternatively, use a screwdriver
to dislodge the battery.
Place the battery in suitable
N
packaging to ensure that the
terminals cannot be short-
circuited.
Take the battery to your service
N
agent or a local recycling
station. Collected batteries
will be recycled or disposed
of properly.