R&G SFP0002BK Instructions De Montage page 2

SPACER R/H/S
(S0683) (x1)
SPINDLE-BAR (EB006)
M12 SHAKE PROOF
WASHER
FITTING INSTRUCTIONS

Fit one nut, plain washer and shake proof washer on to the spindle-bar (EB006) (the end with
shorter thread), engage the nut so the plastic insert of nut is fully engaged.

Feed spindle-bar with nut, plain washer and shake proof washer through either stunt peg
(B0005) then through another shake proof washer, then through the metal spacer (S0682) as
shown in the left hand side picture.

Place this assembly through the front wheel spindle from the left hand side, ensuring the metal
spacer fits into the spindle.

Place the remaining metal spacer (S0683), shake proof washer and stunt peg over the exposed
end of the spindle bar on the right hand side of the bike. The metal spacer should fit inside the
wheel spindle.

Fit the shake proof washer, plain washer and nut from the kit onto thread as shown in the right
hand picture and tighten until both nuts are engaged in nylon and equal amounts protrude from
either side. Do not exceed 40Nm torque.
RIGHT HAND SIDE
TOOLS REQUIRED

Socket set to include 2x 19mm sockets
STUNT PEG
(B0005)
M12 SHAKE PROOF
WASHER
M12 NYLOC
NUT
M12 WASHERS