R&G SFP0002BK Instructions De Montage

Les langues disponibles

Télécharger ce manuel

FITTING INSTRUCTIONS FOR SFP0002BK FORK STUNT PEGS

THIS KIT CONTAINS THE ITEMS PICTURED AND LABELLED BELOW.

DO NOT PROCEED UNTIL YOU ARE SURE ALL PARTS ARE PRESENT.

Please note that the way the kit is packed does not necessarily represent the way of

Please note that in cases where kits are packed with a plastic tube separating components on

HE PARTS SHOWN MAY BE REPRESENTATIVE ONLY

M12 NYLOC NUT (x2)

M12 WASHERS (x2)

BMW S1000RR 2010-

mounting to the bike

the spindle bar (this tube should be discarded).

SHAKE PROOF WASHER

LEFT HAND SIDE

(

FOR CLARITY OF INSTRUCTIONS ONLY

STUNT PEG

(B0005) (x1)

M12 SHAKE PROOF

WASHERS (x4)

)

SPACER L/H/S

(S0682) (x1)

SPINDLE-BAR (EB006)

(380mm LONG) (x1)

Page 1 FITTING INSTRUCTIONS FOR SFP0002BK FORK STUNT PEGS BMW S1000RR 2010- THIS KIT CONTAINS THE ITEMS PICTURED AND LABELLED BELOW. DO NOT PROCEED UNTIL YOU ARE SURE ALL PARTS ARE PRESENT. Please note that the way the kit is packed does not necessarily represent the way of...
Page 2 STUNT PEG SPACER R/H/S (B0005) M12 NYLOC (S0683) (x1) SPINDLE-BAR (EB006) M12 SHAKE PROOF M12 WASHERS M12 SHAKE PROOF WASHER WASHER RIGHT HAND SIDE TOOLS REQUIRED  Socket set to include 2x 19mm sockets FITTING INSTRUCTIONS  Fit one nut, plain washer and shake proof washer on to the spindle-bar (EB006) (the end with shorter thread), engage the nut so the plastic insert of nut is fully engaged.
Page 3 Instructions de montage pour SFP0002BK Pegs de protection latérale pour Stunt BMW S1000RR 2010- Le kit contient les articles exposés ci-dessous, vérifier que toutes les pièces soient présentes avant de procéder au montage. La façon dont le kit est emballé ne correspond pas forcément à la façon de monter les pieces sur la moto.
Page 4 Axe (SB034) Peg de stunt Entretoise coté (B0005) M12 Ecrou Nyloc droit (S0683) (x1) M12 Rondelle anti M12 Rondelles vibration M12 Rondelle anti vibration Coté droit Outils requis  Jeu de clés 2x 19mm Instructions de montage :  Insérer un écrou, une rondelle plate et une rondelle anti vibration sur l’axe (SB034) (l’extrémité...