Black & Decker BDC1A Manuel D'instructions page 6

ENGLISH
Symbols on the charger
The following symbols are shown on the ap-
pliance along with the date code:
+
Warning! To reduce the risk of
injury, the user must read the
instruction manual.
p
Do not attempt to charge dam-
aged batteries.
$
T
he charger is intended for
indoor use only.
Electrical safety
#
Your charger is double insu-
lated; therefore no earth wire is
required. Always check that the
mains voltage corresponds to the
voltage on the rating plate. Never
attempt to replace the charger unit
with a regular mains plug.
6
(Original instructions)
If the supply cord is damaged, it must
u
be replaced by the manufacturer or an
authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
Features
This tool includes some or all of the following
features.
1. Charger
2. Charging indicator
Assembly
Warning! Before assembly, remove the battery
from the appliance/tool.
Fitting and removing the battery
To fit the battery, line it up with the receptacle
u
on the tool. Slide the battery into the receptacle
and push until the battery snaps into place.
To remove the battery, push the battery release
u
button while at the same time pulling the bat-
tery out of the receptacle.
Use
Warning! Let the tool work at its own pace. Do not
overload.