Periodical Maintenance; Extraordinary Maintenance; Decommissioning - Vima MESIS Perfect Waves Pressomassage PSG-PW Manuel D'utilisation

User manual: Perfect Waves PressoMassage

Periodical maintenance

• It is necessary to clean the device on a periodical basis from possible accumulation of
dust that may form on the external frame. Possibly use a compressor to remove dust.
It is possible to use also an alcohol-free non-abrasive damp cloth or without aggressive
solvents. Do not use abrasive sponges, chemicals or detergents. Prevent water from tou-
ching internal electrical parts during cleaning.
• After each use clean the parts of the device that come into direct contact with the user
(see Pre-usage cleaning).
• At the end of the useful life of the accessories, contact the manufacturer for spare parts.
• We recommend to perform a complete check test of the device every 12 months.

Extraordinary maintenance

Extraordinary maintenance is requested in the event of faults or breaks, unforeseeable
accidents or inappropriate use of the device.
The situations that may occur from time to time are completely unforeseeable and therefore
it is not possible to outline appropriate procedures of intervention.
In case of need, refer to the technical service of the manufacturer to receive instructions
appropriate to the situation.
In any case, all ordinary and extraordinary mechanical, electrical or electronic
interventions must be carried out by specialised and authorised staff.

Decommissioning

Device deactivation
The device is manufactured and built according to robustness, duration and flexibility criteria
that allow it to be used for several years. After its technical and operating life cycle, the
device must be decommissioned so that it can no longer be used for the purposes which it
had been once designed and manufactured, while in any case making it possible to reuse
the raw materials which it consists of.
The same deactivation procedures must be observed in all the following cases:
• Device decommissioning and storage in warehouse.
• Final disassembly and subsequent disposal.
NOTE
THE MANUFACTURER ASSUMES NO RESPONSIBILITY FOR DAMAGE TO
PEOPLE OR OBJECTS RESULTING FROM THE REUSE OF SINGLE PARTS
OF THE DEVICE FOR FUNCTIONS OR IN CONFIGURATIONS OF ASSEMBLY
OTHER THAN THE ORIGINAL ONES. THE MANUFACTURER REFUSES ANY
APPROVAL, EITHER IMPLICIT OR EXPLICIT, FOR SPECIFIC PURPOSES OF
PARTS OF THE DEVICE THAT ARE REUSED AFTER FINAL DEACTIVATION
PRIOR TO ITS DISPOSAL.
81
English