Sagi FERMA LIEVITA Manuel D'installation, D'utilisation Et D'entretien page 43

programme, press key
date and press key
During the carrying out of the automatic cycle, on
P2 Locking
T=15°C
display:
the programme in course, BLOCK is the phase in
course T=15°C is the temperature read on the cell
probe.
If the phase foresees also humidification with the
probe, the humidity percentage
displayed.
Pressing key displays the current date and
03/02/06
Mar 17:35
time
data of the cycle in course will be displayed.
Pressing key displays the end date and time
of the phase in course.
Pressing the key again, the end date and
time of the successive phases are displayed.
The phases are coded as follows:
 F0 = block phase
– Duration)
 F1 = Preservation phase
 F2 = Reawakening phase
(Temperature – Humidity - Duration)
 F3 = Proving phase
– Humidity - Duration)
 F4 = Slow down phase
– Humidity)
After 5 seconds, the data of the cycle in course
will be displayed.
End F0
Mon 03/07/06
End F1
Mon 03/07/06
End F2
Mon 03/07/06
End F3
Mon 03/07/06
End Prog 3:00
Mon 03/07/06
, displays the inlets/outlets.
Pressing keys
to confirm the new
to start the cycle.
in which : P2 is
present is
. After 5 seconds, the
(Temperature
(Temperature)
(Temperature
(Temperature
09:30
11:00
12:00
13:00
Using the
displayed:
The meaning of the values highlighted follow:
 Cell
=
probe cell
 Evapor
=
evaporator probe
 Humidity =
humidity probe
 C
=
outlet
1=relay activated)
 D
=
1=relay activated)
 E
=
valve/Light outlet
1=relay activated)
 R
=
outlet
1=relay activated)
 V
=
Evaporator outlet
1=relay activated)
 H
=
generator outlet
1=relay activated)
 U
=
Valve outlet (0=relay deactivated 1=relay
activated)
 DI1
=
(1=inlet active)
 DI2
=
(1=inlet active)
 FAN
percentage.
Chamber
Evapor
Humidity
C D E R V H U
1 0 0 1 1 0 0
DI1
0
At any time, pressing the
cycle. The cycle however, remains selected.
At the end of the cycle (end of proving phase), a
buzzer sounds for 15 seconds. Successively, the
card starts up the slow down cycle.
13
ENGLISH
keys, scroll the sizes to be
Temperature read by the
Temperature read by the
Value read by the
State of the Compressor
(0=relay deactivated
State of the Defrost outlet
(0=relay deactivated
State of the Electric
(0=relay deactivated
State of the Resistance
(0=relay deactivated
State of the Fan
(0=relay deactivated
State of the Steam
(0=relay deactivated
State of the Injection
State of the digital inlet 1
State of the digital inlet 2
= Fan speed in
-6°C
-15°C
80%
DI2 FAN
1 90
key, stops the
GB