Sagi FERMA LIEVITA Manuel D'installation, D'utilisation Et D'entretien page 39

DL1
DL2
DL4
DL3
ED display
Functioning logic as follows.
MANUAL CYCLE
 Cooling
DL1, DL2, DL3, DL4, DL5, DL6 and DL7 are on
in the cooling phase setting.
DL1, DL2 are permanently on, DL3 flashes during
the cooling phase if the setpoint temperature has
not been achieved.
DL1, DL2, DL3, DL4, DL5, DL6 and DL7 are
permanently on during the cooling phase if the
setpoint temperature has been achieved.
 Heating
DL7, DL8, DL9, DL10, DL11 are permanently on
in heating phase setting.
DL7, DL8 are permanently on, DL9 flashes during
the heating phase if the setpoint temperature has
not been achieved.
DL7, DL8, DL9, DL10, DL11 are permanently on
during the heating phase
temperature has not been achieved.
 Air conditioning
DL11, DL12, DL13 are permanently on during the
air conditioning setting.
DL11 is permanently on, DL12 and DL13 flash
during the air conditioning phase if the setpoint
temperature has not been achieved.
DL11, DL12, DL13 are permanently on during the
air conditioning phase if the setpoint temperature
has been achieved.
AUTOMATIC CYCLE
 Blockage
DL11, DL12, DL13 are permanently on during the
blocking phase setting.
DL1, DL2 are permanently on, DL3 flashes during
the blocking phase if the setpoint temperature has
not been achieved.
DL8
DL5 DL6
DL7
if the setpoint
DL10
DL9
DL11
DL1, DL2, DL3 are permanently on during the
blocking phase if the setpoint temperature has
been achieved.
 Preservation
DL3, DL4, DL5, DL6, DL7 are permanently on in
the preservation phase setting.
DL4, DL5 are permanently on, DL6, DL7flash
during the preservation phase if the setpoint
temperature has not been achieved.
DL4, DL5, DL6, DL7 are permanently on during
the preservation phase if the setpoint temperature
has been achieved.
 Reawakening
DL7, DL8, DL9 are permanently on during the
reawakening phase setting.
DL8 is permanently on, DL9 flashes during the
reawakening phase if the setpoint temperature
has not been achieved.
DL8, DL9 are permanently on during the
reawakening phase if the setpoint temperature
has been achieved.
 Proving
DL9, DL10, DL11 are permanently on during the
proving phase setting.
DL10 is permanently on, DL11 flashes during the
proving phase if the setpoint temperature has not
been achieved.
DL10, DL11 are permanently on during the
proving phase if the setpoint temperature has
been achieved.
 Slow down activity
DL11, DL12, DL13 are permanently on during the
slow down activity phase setting.
DL12 on and DL13 off during the slow down
activity phase if the setpoint temperature is higher
or equal to the setpoint temperature of the proving
phase.
DL12 off and DL13 on if the setpoint temperature
is less than the setpoint temperature set in the
proving phase.
NOTE: The led relating to the concluded phases
remains on during the carrying out of the following
phases.
9
ENGLISH
DL12
DL13
GB