Safety Devices; Use And Functioning; Controls Description - Sagi FERMA LIEVITA Manuel D'installation, D'utilisation Et D'entretien

4.6.

Safety Devices

The appliance is equipped with the following
safety systems:
1. Safety Thermostat
blocks the electrical power supply in the event
of excessive overheating.
All cycles in course are blocked and all outlets
deactivated. The display shows the following
ALL Thermostat
message:
5.

USE AND FUNCTIONING

5.1. Controls description

1 2 3
On/Off key (1)
Pressing the ON/OFF key leads to the controller
switching-on. Press the key for 5 consecutive
seconds to switch off the controller.
ENTER key (2)
Pressing the key during normal function, displays
the state of the inlets/outlets.
Pressing within a menu confirms the selection
made.
Vapour Generator:
60 x 80
!
4 5 6
The illustration shows the position of the safety
thermostat.
!
Check daily that the safety devices are
installed correctly and efficient
60 x 40
!
Menu selection key (3)
Pressing the key during a cycle displays the
current date and time. After 5 seconds, the data of
the cycle in course will be displayed. Pressing the
key in STAND-BY accesses the available menu
options.
Increase/Decrease keys (4/5)
These keys are not operational in the main
display. In menu selection they scroll the various
menus; in parameters and humidity set point
programming they decrease or increase the
selected value.
Start Cycle Key (6)
Pressing the key starts or stops a work cycle.
IRDA
INFRA-RED door for programming the
parameters.
7
ENGLISH
GB