Battery Information - ingenuity Comfort 2 Go Portable Swing - Cuddle Lamb Mode D'emploi

Battery Information

The swing control module requires (4) size C/LR14 (1.5V) alkaline batteries (not included).
CAUTION: Follow the battery guidelines in this section. Otherwise, battery
life may be shortened or the batteries may leak or rupture. To prevent battery
leaks, which can burn skin and eyes:
• Always keep batteries away from children.
• Never mix old and new batteries, or batteries of different brands or types.
• Always replace the entire set of batteries at one time.
• Do not mix alkaline, standard, or rechargeable batteries.
• Only batteries of the same or equivalent type as recommended are to be used.
• Install the batteries so that the polarity of each one matches the markings in the
battery compartment.
• Do not short-circuit the batteries.
• Do not store batteries in areas that have extreme temperatures (such as attics,
garages, or automobiles).
• Remove exhausted batteries from the battery compartment.
• Never attempt to recharge a battery unless it is specifically marked "rechargeable. "
• Rechargeable batteries are to be removed from the toy before being charged.
• Rechargeable batteries are only to be charged under adult supervision.
• Dispose of used batteries immediately.
• Please use the correct disposal method for batteries.
• Remove batteries before putting the product into storage for a prolonged period of time.
• Weak batteries cause erratic product operation, including distorted sound, dimming
or failed lights, and slow or non-working motorized parts. Because each electrical
component requires a different operating voltage, replace the batteries when any
function fails to operate.
• Do not dispose of product or batteries in fire, batteries may explode or leak.
This symbol indicates that the product is not to be disposed of in household
waste as batteries contain substances that can be damaging to the environment
and health. Contact local authority for recycling & collection information.
Care and Cleaning
Seat pad – Remove from frame. Fasten buckles on seat restraint and seat pad. Fasten
all hook-and-loop patches to the corresponding patch. Machine wash with cold water,
gentle cycle. No bleach. Tumble dry, low heat.
Bolster – Machine wash with cold water, gentle cycle. No bleach. Air dry flat.
Toy bar and toy – Wipe clean with a damp cloth and mild soap. Air dry.
Do not immerse in water.
Frame – Wipe the metal frame with soft, clean cloth and mild soap.
Storage – When putting swing away for storage, always store in a dry location,
away from any heat sources, and out of the sun.
– 3 –