Makita DUR193 Manuel D'instruction page 12

NOTICE:
Do not use the trimmer as if you dig out
the ground.
Fig.22
Cutting the grass near tree, block,
brick, or stone
Hold and tilt the grass trimmer at a height where the
nylon cutting head does not touch the ground. Cut the
grass using the nylon cord tip like knocking the ground.
Fig.23
NOTICE:
When cutting the grass, move the
grass trimmer around the tree or blocks so that
the nylon cord does not touch the tree or blocks.
It is recommended to keep the tool more than 5 cm
(2") away from the tree or block. If the nylon cord
touch the tree or block, the nylon cord may be torn. If
the nylon cord is torn in the nylon cutting head, set the
nylon cord again referring to the replacement proce-
dure in this manual.
Using the grass trimmer as an edger
Using the grass trimmer as an edger is suitable for
cutting the grass growing along the bricks or blocks.
Open the lock lever, then extend the shaft to the max-
imum length, then rotate the motor housing 180°, and
then close the lock lever.
1
Fig.24
► 1. Lock lever 2. Motor housing
NOTE: You can also rotate the motor housing 180°
when you shorten the shaft to the minimum length.
Lift up the wire guard, and move the grass trimmer as
shown in the figure to cut the grass. You can cut the
grass efficiently by walking in parallel along the bricks
or blocks.
Fig.25
12 ENGLISH
2