Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
– Mount the measuring tool onto a tripod or place it on a firm and level
surface close to wall A. Switch on the measuring tool. Select cross-
line operation with automatic levelling.
– Direct the laser against the close wall A and allow the measuring
tool to level in. Mark the center of the point where the laser lines cross
each other on the wall (point I).
A
B
16 ft (5 m)
– Turn the measuring tool by 180°, allow it to level in and mark the
cross point of the laser lines on the opposite wall B (point II).
A
B
180°
– Without turning the measuring tool, position it close to wall B. Switch
the measuring tool on and allow it to level in.
-22-
Publicité
Table des Matières
