Erreka IZAR MSD-008/00 Guide D'installation Et De Programmation Rapide page 10

Operators without built-in release system
(IZ1C, IZ4C, IZS1, IZS4)
Unlocking for manual operation:
P
• Disconnect the power supply.
• Remove the release pin (1) and move the door
manually.
Motorised operation locking:
• Move the door manually until the crankshaft (2) is
opposite the drive block (3).
• Position the pin (1).
10
Unlocking
D186B
Installation in sectional door (IZS4D, IZ4DC only)
I186A
Operators with built-in release system
(IZS4D, IZ4DC)
Unlocking for manual operation:
P
• Disconnect the power supply.
• Pull the green handle (2) downwards and move the
door manually.
Motorised operation locking:
• Pull the red handle (1) downwards.

In order to use the IZAR operator (IZS4D,
IZ4DC only) in sectional doors, the AIZ01/02
adapter kit, as supplied separately, must be
used. For more information on installing the
IZAR operator in sectional doors, see the
instructions for this adapter.
D186A