Publicité
Les langues disponibles
Les langues disponibles
EN
3
Technical Characteristics
3.1
Drive unit technical specifications
Drive unit
Manufacturer
Operating voltage (V / Hz)
Power consumption (watt)
Protection class
No-load speed (min
-1
)
1)
Core drill bit diameter (mm)
-1
Impact frequency (min
Bit holder
2)
Weight (kg)
Speed electronics
3)
Sound measurement
L
(sound pressure) dB (A)
pA
L
(sound power) dB (A)
WA
Vibration measurement (m/s
The given speeds are to be viewed as maximum speeds for the given diamond drill bit diameters.
1)
Depending on the property of the material to be drilled, such as concrete with steel reinforcement of
different thicknesses, the speed is set "by feel". When drilling through concreted-in steel with large
diamond drill bit diameters the 1st gear is always set.
2)
Weight according to EPTA procedure 01/2003.
Measured values for noise determined according to EN 60745. Wear hearing protection!
3)
4)
Total vibration values (vector sum in three directions) determined according to EN 60745
The vibration emission values given in this instruction manual have been measured according to a method
of measurement standardised in EN 60745 and can be used for comparison between power tools. They
are also suitable for a preliminary estimate of the vibratory stresses.
The vibration emission values given represent the main applications of the power tool. If the power tool is
used for other applications, with different insert tools or are insufficiently serviced, this can significantly
increase the vibratory stresses over the whole work period. For a precise estimate of the vibration
emission values, the times during which the tool is switched off or is running but not actually in use should
also be taken into account. This can reduce the vibration stresses over the whole work period significantly.
WARNING
Health risk due to vibrations.
Î Additional safety measures should be taken
to protect the user, e.g. wearing anti-vibration
protective gloves, correct maintenance
of power tools and insert tools, keeping
hands warm and good organisation of work
sequences.
| 36 |
)
K = 3 dB
2
4)
)
K = 1.5 m / s
Maschinenfabrik OTTO BAIER GmbH
~230 / 50 / 60
1. Gear
480
120 – 250
9600
1¼ UNC and G½
2
BDB 8295
2200
/ II
2. Gear
940
52 – 120
18800
6.02
Yes
91
101
5.5
Publicité
