Publicité
Les langues disponibles
Les langues disponibles
2.6.6 Hazards when using and
handling the power tool
•
If the insert tool becomes blocked, stop
exerting feed and switch off the tool.
Check the reason for the jamming and remove
the cause of jammed insert tools.
•
If you want to restart a diamond drill, which
is in the workpiece, before switching on,
check whether the insert tool rotates freely.
If the insert tool jams, it possibly does not rotate
and this can cause overloading of the tool, or
can cause the diamond drill to detach itself from
the workpiece.
•
Do not use any accessories, which have not
been especially provided and recommended
for this power tool by the manufacturer.
Just because you can attach the accessories
to your power tool is not a guarantee of safe use.
•
The approved speed of the insert tool must
be at least as high as the maximum speed
given on the power tool.
Accessories which rotate faster than approved
can break and fly off the tool.
•
Change insert tools carefully and only use
the mounting tools provided, if they are in
perfect condition. Disconnect the mains
plug before changing the insert tool.
Use of the mounting tool provided prevents
damage to the power tool and insert tool.
•
Never use damaged insert tools. Before
each use, check insert tools for splinters
and cracks. If the power tool or insert tool
is dropped or falls, check whether it is
damaged, or use an undamaged insert tool.
If you have checked and inserted the insert
tool, keep yourself and other people nearby
outside the plane of the rotating insert tool
and let the power tool run at maximum speed
for one minute.
Most damaged insert tools break during this test
period.
•
Do not expose power tools to extreme heat
or cold.
Mechanical and electrical damage can occur
during extreme heat and/or cold.
•
Allow the insert tools, tool holders and other
parts cool in the immediate vicinity of the
work area after use.
The equipment can be very hot after use. Do not
touch or grip the parts. Risk of injury.
•
Additional signs or other, non BAIER-
specific parts may not be screwed or
riveted onto the motor, handle, gearbox or
protective housing.
This could damage the power tool and cause
malfunctions to occur.
•
Avoid unnecessary noise emissions.
•
Note and follow the safety and work
instructions for the accessories used.
2.6.7 Safety instructions for using
long drill bits
•
Never work with a higher speed than the
maximum allowable speed of the drill bit
At higher speeds the drill bit can bend easily,
if it can twist itself free without contact with the
workpiece and result in injuries.
•
Always start drilling at a low speed and while
the drill has contact with the workpiece.
At higher speeds the drill bit can bend easily,
if it can twist itself free without contact with the
workpiece and result in injuries.
•
Do not exert excessive pressure and only
press in the longitudinal direction of the
drill bit.
Drill bits can bend and therefore break or result
in a loss of control and injuries.
2.6.8 Hazards when using and
handling the drill stand
•
Before mounting the drill or drive unit, set
up the drill stand correctly in accordance
with these instructions.
Correct assembly is important to ensure proper,
faultless functioning of the stand.
| 33 |
Publicité
