Publicité
Les langues disponibles
Les langues disponibles
Mounting the UPS to the DIN Rail
1 1 . . 2 2
M M o o u u n n t t i i n n g g t t h h e e U U P P S S t t o o t t h h e e D D I I N N R R a a i i l l
The EATON DIN500AC and DIN850AC UPS can be mounted on "top hat" 35mm DIN rail in accordance with EN60715.
Do not mount the UPS in upside down orientation. Install your Eaton UPS in a protected area with adequate
airflow and free of excessive dust. Do not operate the UPS outdoors.
To Mount the UPS:
1.
Locate the top hook of the DIN rail mounting system on the unit with the unit slightly titled.
2.
Rotate the unit till the latch of the rail mount system snaps on to the bottom of the DIN rail and the unit
cannot be rotated any further.
3.
Shake the UPS slightly to ensure that it is secure.
4.
Check if the UPS is facing upright and not tilting downward.
Figure 2. Mounting the UPS
A A d d j j u u s s t t i i n n g g t t h h e e U U P P S S o o n n t t h h e e D D I I N N R R a a i i l l
To adjust the UPS:
1.
To adjust the spacing between the UPS, pull down the on the DIN rail clamp with a flathead screwdriver or
tool to release the clamp.
2.
Tilt up slightly and adjust to desired spacing and snap back onto DIN rail.
3.
Shake the UPS slightly to ensure that it is secure.
2
Eaton DIN Rail AC UPS DIN500AC / DIN850AC Quick Start User Guide 934183—Rev B
Hook to top of the DIN rail
Listen for a click to ensure the UPS is secured
to the DIN rail.
Publicité
