Pump Saver - Blue Clean AR 142 S Instructions De Montage, D'entretien Et D'utilisation

CARE AND MAINTENANCE CARE AND MAINTENANCE
Storage
• When your pressure washing session has been
completed, turn off the power switch located on the
front of the power washer. Unplug the power cord
from the outlet. Turn off the water supply. Pull the
trigger on the spray gun 2-3 times to drain out the
excess water and to release any remaining water
pressure. Disconnect the garden hose adapter from
the water inlet. DO NOT allow the power washer to
run with no water flowing through it.
• Remove detergent bottle and clean completely.
Residual chemical will stick to the container and can
cause the detergent injector to clog and not
function properly.
• Remove high pressure hose from spray gun.

PUMP SAVER

Pump Saver is a product that protects and prolongs
the life of the pump. This will keep the internal parts
of the pump lubricated and protected from freezing
while being stored in ALL climates. It also assists with
protection from internal corrosion. The Blue Clean
part # is: PW64511 (16oz. bottle). Order online at
www.arblueclean.com
Pump Saver Instructions
Follow the previous storage instructions for your
power washer. To prevent staining, protect the surface
under the power washer from any excess fluid. Wear
eye protection when using this product.
Turn unit off and disconnect all hoses before adding
pump protector. Unscrew threaded top from bottle to
remove seal and reattach threaded top to bottle.
Remove black cap from bottle.
1) Screw garden hose adapter (L) clockwise onto
threaded top of pump saver bottle.
14 14
• Remove lance from the gun. Place the gun in the
holder on the side. Lances are placed into any of the
slots in the back of the unit. Make sure to discard
any remaining detergent from the bottle. Flush the
bottle and nozzle head with fresh water to
prevent clogging.
• Hook the power cord around the cord hook on the
right side of the machine when facing it.
• The pressure hose is stored on the hose hook
located on the back of the handle.
2) To connect, push garden hose adapter (L) and
pump saver bottle firmly into clear quick connect
filter (K), previously installed to pressure washer
inlet.
3) Turn power on. Turn the power washer off as soon
as the pump saver begins to exit the pump outlet.
Note: Instructions on Pump Saver Bottle are generic
and not model specific.
K
L