Dräger Flame 2100 Notice D'utilisation page 18

The alarm delay option affects alarm relay, fault relay, and 0-20 mA
output. The status LED and outputs indicate warnings during the delay
time. When the delay time has passed, status LED and outputs
indicate the alarm.
Possible address setups
A system with up to 247 addresses can be configured.
All manuals and user guides at all-guides.com
Possible modes of operations
Function Setting
Alarm Latch YES: Enable alarm latching.

NO: Disable alarm latching (default).

1)
Automatic BIT YES: Perform automatic & manual BIT

(default).
NO: Perform manual BIT only.

1)
Alarm BIT YES: Successful manual BIT activates

the alarm relay for approximately
3 seconds (default).
NO: Successful manual BIT does not

activate the alarm relay.
2)
Auxiliary Relay YES: Activate auxiliary relay at warning

level.
NO: Activate auxiliary relay at alarm

threshold (default).
(The auxiliary relay is latched only when the
programmable function Auxiliary Relay is
set to YES.)
1, 2)
Auxiliary BIT YES: Successful manual BIT activates

the auxiliary relay for approximately
3 seconds (default).
NO: Successful manual BIT does not

activate the auxiliary relay
2)
EOL YES: Auxiliary relay is used as End of

Line.
NO:

accordance with both auxiliary relay
and auxiliary BIT settings (default).
1) not applicable for Dräger Flame 2370
2) only available in wiring option 4 and 5
en
Use
Auxiliary relay operates in
15