Control Panel - Nilfisk Advance Clarke CR 28 Boost Manuel D'utilisation

CONTROL PANEL

31. Control panel
32. Emergency push-button
33. Horn
34. Scrub and vacuum activation button
35. Extra pressure button
36. Squeegee lifting/lowering and vacuum system on/off button
37. Battery charge indicator
37a. Charged battery warning light (green)
37b. Semi-discharged battery warning light (yellow)
37c. Discharged battery warning light (red)
38. Hour counter and solution level display:
• When the machine is started, it displays for a few
seconds the number of working hours which have been
performed.
• While using the machine, it displays the solution level
in the tank (measured in percentage terms, compared
with the full tank).
• When the level is below 20%, the display starts
blinking.
• The display could indicate "000 %" even if the tank
is not completely empty, allowing to complete the
cleaning procedures; in any case, please check the
actual solution fl ow to the brushes.
34
35
36
33
32
37c 37b 37a
37
39. Forward/reverse gear switch
40. Solution fl ow adjustment
40a. Flow increase button
40b. Flow decrease button
40c. Flow LEDs:
• 0 LEDs on - The solution fl ow is closed.
• 1 LED on - 0.29 gal/min (1.1 liters/min).
• 2 LEDs on - 0.5 gal/min (1.9 liters/min).
• 3 LEDs on - 0.74 gal/min (2.8 liters/min).
41. Maximum speed adjuster (enabled only when the brushes
are operating)
42. Ignition key
38
40a
40c
40b
31
Operator's Manual - CR 28 BOOST®
ENGLISH
41
40
42
39
7
S311212A