Publicité
Les langues disponibles
Les langues disponibles
Icons during boot up
The LCD displays two icons as the hosting appliance boots: a square
divided into four sections and an hourglass. When the upper right
section of the square is black, the hosting appliance is in POST
(performing Power-On Self Test). When both upper sections of the
square are black, the hosting appliance is preparing to load the
operating system. The hourglass symbol will appear until the operating
system starts and the splash screen appears.
To assign a static IP address
1. After booting, the hosting appliance displays the Set IP
Address menu with blank octets. Enter an IP address for
the hosting appliance by selecting a number for each zero
in each octet:
000.000.000.000 x
2. For each zero in each octet, use the up button to change
the value from 0 to 1, 2, 3, and so on. All numbers must be
entered using three digits. For values less than 100, this
will require at least one padding zero. As an example, 5
would be entered as "005" while 79 would look like "079."
You can't set an octet outside the maximum value (255) or
the minimum value (000).
3. To move the cursor from one zero to another zero, use the
right or left buttons. If the cursor is in the square space,
pushing the down button advances you to the next
screen.
9
Publicité
