Publicité
Les langues disponibles
Les langues disponibles
Booting up and assigning
addresses, masks, and default
gateways
The hosting appliance is "headless," and can be administered
remotely using the hosting appliance browser interface (in
Netscape Navigator* 4.73 or Internet Explorer* 5.0). Before your
browser can "see" the hosting appliance, you must do the
following:
•
Boot the hosting appliance
•
Assign a static IP address
•
Assign a subnet mask
•
Set the default gateway
Error codes
If you see "XXXX" (a four-digit number) on the LCD, it's an error code.
During boot up, the hosting appliance will display error code 0109
indicating that a keyboard is not attached to the hosting appliance.
Please ignore this error code, and do NOT use a keyboard or mouse with
the hosting appliance. You may have to press the power button, then
press it a second time to begin the cycle again. Find definitions of the
error codes at: http://www.hp.com/serverappliances/support
To boot the hosting appliance
1. Grasp the pull tab on the right end of the hinged bezel
door (See Figure 1).
2. Gently pull the tab down to swing open the hinged bezel
door.
3. Press the power button (See Figure 2).
4. Wait approximately 1-3 minutes while the appliance
boots. A splash screen will appear on the LCD while the
software loads.
8
Publicité
