Before You Begin - Kohler MASSDREAM E5BE 00 Serie Notice D'installation

Please read these instructions carefully before installing your product and keep them for future reference.
Inspect bath and fittings before starting work.

Before you begin

This unit should not be used by individuals (including children) with reduced physical, sensory or mental capacities;
nor by people lacking experience or knowledge thereof, unless they are supervised by an individual who is responsible
for their safety, or have received prior instructions about using this unit from such an individual.
IMPORTANT!
Never use the bathtub's fittings as carrying handles. Handle the bathtub by its edges only.
Basic Principles for installation
This appliance shall only be installed or repaired by persons who can demonstrate awareness and competence
in the application of the national regulatory requirements for electrical installations and connections to the water
supply and drainage.
The electrical installation must comply with the relevant national requirements for electrical installations, building
regulations and any particular regulations or practices specified by the local electricity supply company.
Ensure that these instructions are left with the user and are passed on to subsequent owners and users.
Fill the bath with water and test thoroughly to ensure correct operation and that there are no leaks before completing the apron.
An access panel(s) shall be provided to allow access to the pipework and whirlpool components for maintenance
or repair purposes. Access panels must not be able to be opened without the aid of a tool, and shall be labelled
"Caution: Disconnect unit from power before servicing".
An air vent of minimum dimensions 120mm x 90mm
of the whirlpool components.
Ensure that the floor is flat and level. This will minimise adjustments needed to ensure
that the product works properly.
Installation must be performed by an approved installer in accordance with local trade practices (please refer
to the FISB document next page).
3 0/6.0mm
(2 dm minimum)
2
shall be provided to ensure adequate cooling
1 0