Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installing the bathtub
Installing a Class E type bath (see "General installation instructions"). Bath surrounded by four low walls or positioned
against one or several walls, with the other sides positioned against low walls.
- Regardless of your installation layout, the bath should never touch the walls or the ground in order to avoid causing
noise, vibrations or relative motion.
- Allowance should be 5 mm along the perimeter of the bath and 5 mm along the height.
- Move the bath into final position.
- Adjust the pads to position the bath perfectly level.
Install two lateral supports (not supplied) to walls, depending on your layout
Warning
- Disconnect the bathtub from the mains
before installation.
- Never fix the anti-vibration feet to the floor.
Acoustic kit (optional réf: E6D035-NF)
(x7)
Vibration absorber pads
to affix to side supports
(6 pads for the supports)
1
2
1. Lay three vibration absorber pads
on each peripheral support.
2. Position self-adhesive side of insula-
ting strip along bath return on the
wall side.
(x2)
Fixing bracket
Insulation roll
3
3. Cut off remaining pad
into two sections.
4. Position one half-pad
behind each fixing
bracket.
(x1)
6
5. Screw in fixing brackets
6. Fold other part of the strip over bath
1 3
4
rim (this part will be removed after the
tiling is in place; cf panel/wall finish,
page 15).
5
Publicité
Table des Matières
