Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Section
Audio Adjustments
08
Using non fading output
When the non fading output setting is on, the
audio signal does not pass through this unit's
low pass filter (for the subwoofer), but is output
through the RCA output.
1 Press
to select non fading output on/off
A
mode.
When the subwoofer controller setting is
, you can select non fading output
Control:EXT
on/off mode. Press
in the display.
• Pressing
AUDIO
forms the same operation.
2 Press E to turn non fading output on.
appears in the display. Non fading
NonFad ON
output is now on.
• You can turn off non fading output by pressing
e.
• Pressing 5 or ∞ on the head unit also per-
forms the same operation.
Adjusting non fading output level
When the non fading output is on, you can
adjust the level of non fading output.
1 Press
to select non fading output setting
A
mode.
Press
until
A
NonFad 0
• Pressing
AUDIO
forms the same operation.
2 Press E or e to adjust the output level
of the non fading.
Each press of E or e increases or decreases
the level of the non fading (e.g.,
Press E or e until you see the desired value
displayed.
• Pressing 5 or ∞ on the head unit also per-
forms the same operation.
62
En
S.W
until
appears
A
NonFad ON
on the head unit also per-
appears in the display.
on the head unit also per-
to
).
+6
–6
Using the high pass filter
When you do not want low sounds from the
subwoofer output frequency range to play from
the front or rear speakers, switch the HPF (high
pass filter) on. Only frequencies higher than
those in the selected range are output from the
front and rear speakers.
1 Press
to select
A
HPF
Press
until
appears in the display.
A
HPF
• Pressing
on the head unit also per-
AUDIO
forms the same operation.
2 Press E to turn high pass filter on.
appears in the display. High pass
HPF 80 Hz
filter is now on.
• To turn high pass filter off, press e.
• Pressing 5 or ∞ on the head unit also per-
forms the same operation.
3 Press 1 or ¡ to select a high pass filter
range.
Press 1 and
HPF 50 Hz
and
is displayed. Only frequencies higher
125 Hz
than those in the selected range are output
from the front or rear speakers.
• Pressing 2 or 3 on the head unit also per-
forms the same operation.
Note
• If you switch the
SFEQ
tion is automatically switched off. By switch-
ing the
function on after selecting the
H.P.F.
mode, you can combine
SFEQ
with
function.
SFEQ
.
is displayed. Press ¡
mode, the
func-
H.P.F.
function
H.P.F.
Publicité
Chapitres
Table des Matières
Dépannage
