Setting Remote Control Code Type; If You Forget Your Code Number - Pioneer DVH-P7000 Mode D'emploi

Section
Initial Settings for
09
DVD player

Setting remote control code type

When the remote control operation switch is set
to , changing the remote control code type
DVD
enables you to operate the Pioneer DVD player
by the supplied remote control. There are three
remote codes, code type
code type .
DVH
When using this unit with an Multi-DVD Player
(e.g. XDV-P90), select code
When using this unit with a DVD Navigation
Unit, select code
When using this unit only, select code
1 Set the remote control selection switch on
the left side of the remote control to the
appropriate position with a pen tip or other
pointed instrument .
• If you select
DVH
take the following procedure.
• If you select
A/B
procedure and change the code type to the
appropriate type.
2 Pressing and
7
simultaneously changes the code type.
Initially, the code type is set to
Each time you press
the remote control the code type changes
between and
A B
72 En
, code type
A B
.
A
.
B
DVH
mode, there is no need to
mode, take the following
on the remote control
0
.
A
and simultaneously on
7 0
.

If you forget your code number

Refer to Changing the Level, step 3 on page 68,
and press
The registered code number is canceled, letting
you register a new one.
and
.
10 times.
CLEAR