Electrical Safety - Black & Decker KR705 Mode D'emploi

ENGLISH
Warning! To reduce the risk of injury, the user must
read the instruction manual.

Electrical safety

This tool is double insulated; therefore no earth wire
is required. Always check that the power supply
corresponds to the voltage on the rating plate.
• If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised Black & Decker Service
Centre in order to avoid a hazard.
Features
This tool includes some or all of the following features.
1. Variable speed switch
2. Lock-on button
3. Variable speed control knob
4. Forward/reverse switch
5. Drilling mode selector
6. Chuck
7. Depth stop
8. Side handle
Assembly
Warning! Before assembly, make sure that the tool is
switched off and unplugged.
Fitting the side handle and depth stop (fig. A)
• Turn the grip counterclockwise until you can slide the
side handle (8) onto the front of the tool.
• Rotate the side handle into the desired position.
• Insert the depth stop (7) into the mounting hole as
shown.
• Set the drilling depth as described below.
• Tighten the side handle by turning the grip clockwise.
6
Setting the drilling depth (fig. A)
• Slacken the side handle (8) by turning the grip
counterclockwise.
• Set the depth stop (7) to the desired position. The
maximum drilling depth is equal to the distance between
the tip of the drill bit and the front end of the depth stop.
• Tighten the side handle by turning the grip clockwise.
Fitting an accessory (fig. B & C)
Keyless chuck with spindle lock (Where supplied)
(fig. B)
• Open the chuck by turning the sleeve (9)
counterclockwise.
• Insert the bit shaft (10) into the chuck.
• Tighten the chuck by turning the sleeve clockwise.
Keyed chuck (Where supplied) (fig. C)
• Open the chuck by turning the sleeve (11)
counterclockwise.
• Insert the bit shaft (10) into the chuck.
• Insert the chuck key (12) into each hole (13) in the side
of the chuck and turn clockwise until tight.
Removing and refitting the chuck (fig. D)
• Open the chuck as far as possible.
• Remove the chuck retaining screw, located in the chuck,
by turning it clockwise using a screwdriver.
• Tighten an Allen key into the chuck and strike it with a
hammer as shown.
• Remove the Allen key.
• Remove the chuck by turning it counterclockwise.
• To refit the chuck, screw it onto the spindle and secure it
with the chuck retaining screw.