Electrical Safety - Black & Decker CS3651LC Mode D'emploi

♦ Injuries caused by prolonged use of a tool. When
using any tool for prolonged periods ensure you
take regular breaks.
♦ Impairment of hearing.
♦ Health hazards caused by breathing dust devel-
oped when using your tool (example:- working
with wood, especially oak, beech and MDF.)
Vibration
The declared vibration emission values stated in
the technical data and the declaration of conformity
have been measured in accordance with a standard
test method provided by EN 60745 and may be used
for comparing one tool with another. The declared
vibration emission value may also be used in a pre-
liminary assessment of exposure.
Warning! The vibration emission value during actual
use of the power tool can differ from the declared
value depending on the ways in which the tool is
used. The vibration level may increase above the
level stated.
When assessing vibration exposure to determine
safety measures required by 2002/44/EC to protect
persons regularly using power tools in employment,
an estimation of vibration exposure should consider,
the actual conditions of use and the way the tool is
used, including taking account of all parts of the
operating cycle such as the times when the tool is
switched off and when it is running idle in addition
to the trigger time.
Labels on tool
The following symbols are shown on the tool:
Warning! To reduce the risk of injury, the
user must read the instruction manual.
Additional safety instructions for
batteries and chargers
Batteries
♦ Never attempt to open for any reason.
♦ Do not expose the battery to water.
♦ Do not store in locations where the temperature
may exceed 40 °C.
♦ Charge only at ambient temperatures between
10 °C and 40 °C.
♦ Charge only using the charger provided with the
tool.
♦ When disposing of batteries, follow the instruc-
tions given in the section "Protecting the envi-
ronment".
Chargers
♦ Use your BLACK+DECKER charger only to
charge the battery in the tool with which it was
supplied. Other batteries could burst, causing
personal injury and damage.
♦ Never attempt to charge non-rechargeable bat-
teries.
♦ Have defective cords replaced immediately.
♦ Do not expose the charger to water.
♦ Do not open the charger.
♦ Do not probe the charger.
The charger is intended for indoor use only.
Read the instruction manual before use.
Fail safe isolating transformer. The mains
supply is electrically separated from the
transformer output.
The charger automatically shuts off if the
ambient temperature becomes too high. As
a consequence the charger will be inoper-
able. The unit must be disconnected from
the mains supply and taken to an authorised
service centre for repair.

Electrical safety

Your charger is double insulated; therefore
no earth wire is required. Always check
that the mains voltage corresponds to the
voltage on the rating plate. Never attempt
to replace the charger unit with a regular
mains plug.
♦ If the supply cord is damaged, it must be re-
placed by the manufacturer or an authorised
BLACK+DECKER Service Centre in order to
avoid a hazard.
Warning! Never attempt to replace the charger unit
with a regular mains plug.
Features
This tool includes some or all of the following
features.
1. On/off switch
2. Forward/reverse slider
3. Bit holder
4. LED work light
5. Charger
6. Charger plug
7. Charging connector
Assembly
Fitting and removing a drill bit or
a screwdriver bit (fi g. B)
This tool uses screwdriver bits and drill bits with
a 6.35 mm (1/4") hexagonal shank.
ENGLISH
7