Drinkwell Platinum Mode D'emploi page 8

5) Once the stator is removed you can
also remove the impeller (3 white-
bladed propeller) which is held in
place magnetically. To remove the
impeller use a fingernail to get under
a blade and lift out.
6) Once the motor is disassembled you
can clean the parts with warm soapy
water. Use a cotton swab
(Q-Tip) or the Drinkwell
Kit "Motor Brush" to get into the motor cavity
and remove any build-up. For added disinfecting and hard water removal
clean the motor with white vinegar.
7) Once the parts are clean you can reassemble the motor for use.
a) Replace the impeller
b) Replace the stator
c) Replace the intake plate with the flow control knob attached to it.
THE FOUNTAIN AND YOUR ENVIRONMENT
If you live in a humid environment and have problems with mold or algae, (the
parts may feel "slimy"), simply soak all of the parts in a diluted bleach solution for
about 10 minutes after regular cleaning. (Use one or two cups of bleach in a sink
full of water). Pour some of the bleach solution down into the motor cavity, too.
This is also an excellent way to disinfect the fountain. You must be sure to rinse all
the parts very well to remove all the chlorine. The best way to rinse out the motor
cavity is to hold it under a weak stream of water.
If you have "hard water" you may start to see white mineral deposits on or down
inside the motor. This may eventually prevent the impeller from turning properly.
To avoid having to replace the motor:
A. Clean the motor more frequently than you have in the past; or
B. Clean with regular white vinegar and let the vinegar soak for
several minutes down inside the cavity; or
C. Use bottled water.
www.petfountain.com
®
Cleaning
Fig. 4f
p. 8