Drinkwell Platinum Mode D'emploi page 10

UNDERSTANDING THE DRINKWELL PARTS
There are several parts to the Drinkwell
1) Housing Cover: the cover or lid snaps in place over the filter
housing well, keeping pets out of the charcoal filter.
2) Housing: here the water is pumped up through the housing to
cycle through the charcoal filter and out the spout to create a long
five-inch waterfall into the bowl.
3) Pre-filter: a small intake grate that will catch large particles such
as hair and kibble before they reach the filter. The pre-filter can be
removed by pulling up on the lip at the top. To replace, slide back
into place over the flow control knob and push down until it clamps
around the knob.
4) Bowl: the Drinkwell
features two handles on either side of the fountain as well as a
"cord channel" to hide the cord from view.
5) Flow Control Knob: the black knob that attaches to the motor
which will adjust the rate of water flow. The pre-filter will snap
around the neck of the flow control knob which will lock it into
place. The knob is attached to the motor and can be removed by
taking the motor apart (See section "Motor Maintenance").
6) Motor or Pump: a small submersible aquarium pump that can
be dismantled for cleaning. THE PUMP IS NOT DISHWASHER
SAFE! Remove pump from fountain before cleaning (See "Motor
Maintenance") The pump cord also features a removable inline
plug for easy attachment.
7) Reservoir: the extra capacity reservoir holds over a half gallon of
water. The plugging cap will help to minimize spills when you refill
the reservoir.
www.petfountain.com
described here in detail.
® bowl is the foundation of the fountain. It
Platinum that will be
®
p. 10