Drinkwell Platinum Mode D'emploi page 2

DRINKWELL
Platinum
OPERATING INSTRUCTIONS
Your fountain will come fully assembled and ready for use.
1) As with any electrical device, check the electrical cord for any tears, or
damage before use.
2) Make sure the inline plug is connected. (No silver showing)
3) Remove the housing cover (lid) by placing your index fingers into the inset
groves on either side of the lid. Lift up. Set the lid aside.
4) Lift up the reservoir and check to make sure the intake tube is properly
inserted into the motor. (Fig. 1a &1b)
5) Insert the charcoal filter. The filter will fit into the two triangular slots in the
center of the housing. The filter fits narrow side
down and the black side faces the front of the
fountain. The filter will slide easily into place.
a. Note: Rinse the filter thoroughly under cool
water before placing into the housing. This
will remove any loose charcoal dust, which
is harmless. A small amount of charcoal
dust may shed for the life of the filter. This is
normal and not harmful to your pet. (Fig. 1c)
www.petfountain.com
U.S. Patents No. 5,799,609 and 5,842,437
D O N O T R U N D R Y
FOR INDOOR USE ONLY
Fig. 1a
®
®
Fig. 1b
Fig. 1c
p. 2