Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Loop system planning.
The majority of the concerns of induction loop happen when the installation hasn't been
correctly considered. Let's take some time before starting the installation and let's have
time and results benefits.
Ideally, the loop amplifier must be placed near to the area it has to cover. It can entail to place the
amplifier on a panel, under a desk or a table.
DCL20-K & DCL20-SA : The sound recording microphone must be placed as near as possible to the
amplifier input.
DCL20-TV & DCL20-SA : The amplifier must be placed as near as possible to the audio source (TV, sound
system...etc)
To position the loop in the area that you have to equip, it is important to take future users into account.
For example, if you only have to plan speaker and client, a loop around the desk can be a better solution
rather than a loop around the perimeter of the room. It will limit shinning and will increase
confidentiality. For a TV room equipment, it's recommended to tug the loop around the room to enables
several user to use the equipment.
Installation configuration of the system selection
Choose one of the following configuration setup :
A. Counter loop system installation (DCL20-K) : Page 3
Publicité
Table des Matières
