Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
A. Counter loop system installation (DCL20-K)
The coil provided in DCL20-K kits enables to ensure a fast installation of a loop system in a reception desk,
counter or cash desk.
In order to optimize the magnetic field shinning and to ensure a better result, the coil must be placed as
near as possible to the client.
Loop's composition and assembly
Counter loop installation
There are 3 counter loop placement possibilities as
described below, however, we recommend you to use
the first one :
1.
Place the loop on the vertical and horizontal section
as illustrated on the figure 1. This kind of installation
ensure a better coverage in front of the desk.
2.
Place the loop on the horizontal section of the
counter while placing the wire as near as possible to the
client.
3.
Place the loop on the horizontal section of the
counter while placing the wire as near as possible to the
client.
Fix the loop thanks to fixations clips provided for the purpose. For more durability, it may be appropriate
to install the loop in a plastic channel.
To DCL20
The loop includes 3 elements : a RJ12 cable (E), a RJ12
loop adapter (F), a loop
adhesive clips (H).
To create the loop which will enable to equip the
counter, connect the beggining and the end of the RJ12
wire on the adapter.
Then, connect the link wire (G) on the adapter's
terminal block.
Your final loop is now created.
amplifier link and a kit of
Publicité
Table des Matières
