Power cable entry to the heater should be made through
one of the knock-out holes located on the back plate or
top/bottom ends of the unit. Use the appropriate strain
relief fitting.
The power leads are to be secured to the L1 and L2 or L
and N connectors on the terminal block or relay. The
ground lead is to be secured to the GND connector on the
block or the green ground wire with the provided wire nut.
FAILURE TO GROUND THE SYSTEM MAY RESULT IN SERIOUS INJURY, DEATH AND/OR
PROPERTY DAMAGE.
Leave the breaker in the "OFF" position. Proceed to the
next section:
Information contained in this document is subject to change without notice.
238-54367-00A REV 09/21
8