Makita DCU603 Manuel D'instructions page 23

17. Unless the tool supports the use near
high-voltage electrical power lines, do not use
the battery cartridge near high-voltage electri-
cal power lines. It may result in a malfunction or
breakdown of the tool or battery cartridge.
18. Keep the battery away from children.
SAVE THESE INSTRUCTIONS.
CAUTION:
Only use genuine Makita batteries.
Use of non-genuine Makita batteries, or batteries that
have been altered, may result in the battery bursting
causing fires, personal injury and damage. It will
also void the Makita warranty for the Makita tool and
charger.
PARTS DESCRIPTION
DCU603
► Fig.1
1 Control panel
3 Switch trigger
5 Handle
7 Brake lever
9 Rear wheel lock
11 Front wheel
13 Bucket
DCU604
► Fig.2
1 Control panel
3 Switch trigger
5 Handle
7 Brake lever
9 Rear wheel lock
11 Front wheel
13 Carrier
DCU605
► Fig.3
1 Control panel
3 Switch trigger
5 Rear wheel lock
7 Battery box
9 Rear wheel
11 Front lamp
13 Flat bucket
2 Beep button
4 Rear lamp
6 Battery box
8 Rear wheel
10 Lock lever
12 Front lamp
- -
2 Beep button
4 Rear lamp
6 Battery box
8 Rear wheel
10 Lock lever
12 Front lamp
- -
2 Beep button
4 Rear lamp
6 Handle
8 Brake lever
10 Front wheel
12 Cap
- -
Tips for maintaining maximum
battery life
1. Charge the battery cartridge before completely
discharged. Always stop tool operation and
charge the battery cartridge when you notice
less tool power.
2. Never recharge a fully charged battery car-
tridge. Overcharging shortens the battery
service life.
3. Charge the battery cartridge with room tem-
perature at 10 °C - 40 °C (50 °F - 104 °F). Let
a hot battery cartridge cool down before
charging it.
4. When not using the battery cartridge, remove
it from the tool or the charger.
5. Charge the battery cartridge if you do not use
it for a long period (more than six months).
CONFIGURATION OF
MACHINE
When the bucket is installed
► Fig.4
1 Bucket
3 Base unit
When the carrier is installed
► Fig.5
1 Carrier
3 Base unit
When the flat bucket is installed
► Fig.6
1 Flat bucket
ASSEMBLY
CAUTION:
Always be sure that the machine
is switched off and the battery cartridges are
removed before carrying out any work on the
machine.
Before installing or removing the carrier, bucket, flat
bucket, or dump unit, be sure to lock the brake lever.
To lock the brake lever, pull and hold the brake lever,
then pull the lock lever, and then release the brake lever
while pulling the lock lever.
► Fig.7: 1. Brake lever 2. Lock lever
23 ENGLISH
2 Dump unit
- -
2 Dump unit
- -
2 Base unit