Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
WARNING
If you do not fully seat the quick-attach
pins through the attachment mount plate,
the attachment could fall off the machine,
crushing you or bystanders.
Ensure that the quick-attach pins are fully
seated in the attachment mount plate.
Preparing for Operation
1.
Drive to the work location.
2.
If you are using the backhoe with a TX1000,
ensure that the hook-and-loop strap (provided in
the Fit-Up Kit) is installed on the control panel;
refer to the Fit-Up Kit Installation Instructions.
3.
Remove the 2 pins locking the boom in place
(Figure 6
and
Figure
storage positions
Note:
One pin prevents the boom from swinging
side to side
(Figure
the boom from moving up and down
1. Pin
1. Pin
7) and place them in the
(Figure
8).
6) and the other prevents
(Figure
Figure 6
Figure 7
4.
Push the stabilizer control levers forward to
lower both stabilizers until they touch the ground
and the front wheels of the traction unit come off
of the ground slightly.
5.
Set the throttle to half speed.
7).
Digging a Hole
Using a backhoe with precision and proficiency takes
time and practice. In general, dig a hole by extending
the dipper and bucket, lowering them into the ground,
and then pulling back on the dipper while raising the
boom and curling the bucket backward
g352157
g352158
9
Figure 8
(Figure
Figure 9
g352175
9).
g348183
Publicité
Table des Matières
