Product Use - Nuna ZAAZ Mode D'emploi

Product Use

Adjusting the Seat Height
WARNING DO NOT adjust the height of the chair while a
child is in the seat!
1
- Slide down the lock behind the flap and lift the flap
completely. The seat automatically rises up to the
highest position. (2)
2
- To lower the seat, keep the flap lifted completely and
push down firmly on the sitting surface of the seat until
it reaches the desired position. (14)
3
- Lower the flap down into position. Listen for the click as
the lock clicks back into position. The seat position is
now locked.
Adjust the Harness Restraint and Buckle
1
- To release the buckle, push on the Nuna button at the
center and remove the two clips. (16)
2
- To lock the harness, insert each clip into the buckle and
listen for a click. (17)(18)(19)
3
- Don't forget to check and adjust the harness to fit your
child snugly. (20)
Remove the Tray
1
- Release the two clips on both sides under the tray. (13)
2
- Gently lift the tray upwards so that it clears the armbar
and pull away from the back of the seat.
Remove the Armbar
1
- Push the button on the front of the armbar and pull the
armbar up to release it from the seat. (11)
11 ZAAZ instructions
2
- Unhook the two ends from the backrest and remove.
(10)
When removing the armbar for cleaning, ensure that
the armbar is securely reassembled when placing it
back on the high chair. Refer to "Assemble ArmBar
onto Seat."
Remove the Harness Restraint
WARNING When used as a high chair, the child must
always wear the harness restraint correctly fitted and
adjusted. The chair complies with the high chair European
standard (EN14988:2017) only when the harness is fitted.
The harness can be removed for cleaning or when the chair
is used for an older child.
Insert the Nuna key into each of the slots of the harness
restraint at the back and underside of the seat to release the
plastic clips. Pull on the belts to remove. (15)
Remove the Seat Cushion
1
- To remove the seat cushion, first remove the tray, the
armbar and the harness restraint if necessary.
2
- When removing the seat cushion always remove the
cushion retainer by inserting the Nuna key into the slot
on the underside of the seat. (21)
Remove the Footrest
1
- Slide down the lock behind the flap and lift the flap
completely.The seat automatically rises up to the
highest position. (2)
2
- Firmly flex one end of the footrest and unhook it from
the flap. Unhook the other end and remove it. (4)
3
- Remember to lower the flap and listen for the click as
the lock clicks back into position.
ZAAZ instructions 12