Installing The Main Unit - JVC KW-Z1000W Guide De Démarrage Rapide

Connection/Installation
5) Adjust the direction of the microphone
(accessory 3) to the driver.
3
Fix a cable with a commercial item of tape.
Ñ

Installing the main unit

NOTE
• Determine the slider position before installing the
main unit. (P.26) The slider position cannot be
changed after installing to the vehicle.
• Make sure that the unit is installed securely in
place. If the unit is unstable, it may malfunction
(eg, the sound may skip).
1
Remove parts that interfere with
installing such as a panel on the vehicle.
2
Install the car bracket to the main unit.
Car bracket
4 or 5
3
Connect the wiring harness wires and
peripheral equipment.
4
Install the main unit to the vehicle.
5
Reinstall the removed parts such as a
panel on the vehicle.
Main unit
28
6
7
8
Main unit
Panel on the
vehicle
9
Install the display unit (accessory 8) to
the main unit.
NOTE
• If the display unit hits a panel on the vehicle,
adjust the display height by referring to
Adjusting the display height (P.27).
Fix the display unit with six hexagon head
screws (accessory -).
-
Attach the protective cover (accessory =)
to coupling part, and then fix it with two
binding head screws (accessory ~).
~
NOTE
• If the protective cover (accessory =) is not attached,
this unit will not turn on. Even if the unit is turned
on, the power may be turned off halfway.
Be sure to attach the protective cover (accessory =).
Raise the display manually.
Main unit
8
=